Cart

0
Sub-Total: 0.00

No products in the basket.

Taps

The Salutec under sink water filtration system can be easily installed by either your preferred plumber or a plumber from our specially trained team.

Depending on your installation requirements, we can provide you with a variety of tapping solutions and accessories.

The diagram below provides three solutions for tapping that may suit your needs. If you require additional advice, please get in touch with our team.

Solution A (left), Solution B (middle), Solution C (right)
Solution A (left), Solution B (middle), Solution C (right)

Solution A, Two Tap Solution. Provides clear separation between service water (utility water) and drinking water (arrow). When the old tap remains, a small second tap for the filtered water will be installed (arrow). It requires a second bore hole drilled in the work top or punched in the stainless-steel sink. Diameters vary between 12 mm, 14 mm and 18 mm. The feed into the filter begins with a T-piece in the supply line. Taps are available in chromium plated high-alloyed and lead-free brass or inert stainless steel. The taps connect easily with a swirler if desired. For Solution A, you will need either a Novara Tap or an Alba-2 Tap.

Solution B, One Tap Solution. A streamlined solution that requires a special tap with two internal conduits, two outlets and extra valve for the filtered water (arrow). The taps connect easily with a swirler if desired. It needs a bore hole of 36 mm diameter. The old hole can be used in general and may require finishing. The feed into the filter begins with a T-piece in the supply line. A low-pressure hot water tank or a no pressure flow heater requires the installation of a specially tap designed for low pressure hot water systems. Taps are available in chromium plated high-alloyed lead-free brass or inert stainless steel. For Solution B, you will need a Verona Tap or a Florenz Tap.

Solution C, Old Tap Solution. All water is filtered with this solution and no further tap installation is required. A filter cartridge with a high capacity may be useful (ABF Duplex® SD). The filter will be connected with the cold water directly. A T-piece is also not required nor is the additional bore hole. We recommend this solution at a tapping station, e.g. in a restaurant or a school. A swirler may require an adapter on the tap outlet.

VIEW OUR RANGE OF TAPS
Reset
Reset
              Reset
              Reset
              Share Page Link :
              ×
              General Tasks are meant for requests that are not about a specific part of the page. To create a specific request, close this box and click the plus icon on the right to choose any part of the page.
              For more generic requests, go ahead and send your message.
              ×
              Approve Page

              When the page is ready, click the green button to signal to the webmaster that this page is approved.

              there was some error. Please try again.
              ×
              Page Approved
              Desktop Tablet Mobile
              Back to Standard View